AC Communications Splicer
Dur-A-Lift DTAS2-35TS
DTAS2-35TS 35’ telescopic articulated aerial, non-insulated
- Pedestal Riser
- 36’ of platform height
- 41’ of working height
- 27’6” side reach
- Platform capacity of 350 lbs.
- Bucket configured as follows:
- 24” x 30” x 42”
- End hung bucket
- Walk thru bucket with door
- Electric toggle switch
- Emergency Power
- Engine Start/Stop
- 370 degree Non-Continuous rotation.
- Open center hydraulic system
- Non-relube bearings used throughout.
- Integral hydraulic oil reservoir with dual sight gauges
- Emergency Power Insulated 12V DC hydraulic system.
- Master / Slave hydraulic leveling with upper and lower control to tilt for cleanout or rescue.
- Lower remote controls mounted in rear compartment
- Upper boom storage cradle with ratchet type tie down strap and tubular rubber platform support.
- Body harness and lanyard.
- Standard white urethane paint.
- Two operator’s manuals and two service manuals.
- ANSI A92.2 Data plate.
- Internal hydraulic tank
- Generator driven hydraulic pump
- Open circuit operation
- Emergency Brake Interlock
Brand FX Fiberglass Service Body, BFXB-84
- 132” long x 42” high x 94” wide.
- 84” CA with dual rear wheels.
- 42” compartment height
- 20” compartment depth
- 25” body mounting height
- One (1) Birch countertop installed on the top of the curbside side compartment
- structure. Counters shall extend from the rear of the body and be approximately
- 96” long x 24” wide x by 2” thick. Directly below this counter area shall be storage
- created by aluminum risers supporting the counter. HEIGHT TBD per customer
- One (1) curbside corner hinged splicing door
- Fasclamp Fiber hold down fixture
- Streetside compartment tops left open
- Four (4) ECCO #EW0701, 21.5” LED ceiling light, 12 vdc, switched and mounted on the ceiling above the counter. Controlled by a switch at the rear doors
- One (1) Ventline 14” x 14” Roof Vent, with crank open dome and 12 vdc powered integral fan. Controlled by a switch at the rear doors
- Carbon Monoxide Monitor and Alarm
- One (1) 24” x 15” curbside sliding body window with screen, Motion Window model #1100
120 VAC:
- Install a Predator 9500 watt Gas Inverter/Generator on the streetside of the tailshelf.
- 9.5 kW output
- 58.3 amp
- 120 VAC
- 60 Hz, single phase
- GE TPL Weather Resistant Breaker Panel in the streetside rear compartment
- One (1) Plugmold outlet strips shall be provided one at the counter area. Each strip shall be approximately 48” long and be equipped ten (10) outlets wired to operate from the generator
- 120 VAC, 15 amp
Build Me This Truck
Fill out the form below and a member of our sales team will be in contact regarding your quote! Please add any changes or requests to the Additional Notes.